The problem occurred in both roughing and finishing passes. Fixed an issue for Turning Profile operations in which leads were not generated at an angle with respect to the toolpath direction when "Use Fixed Lead Direction" was turned off.It is now: outer radius, inner radius, retract, clearance. Fixed the order of the radii fields in the radii tab for turning operations to be more logical.For inside turning toolpaths, fixed the error message that popped up when the clearance radius was set to be smaller than the retract radius.For a new turning setup, set the default safe Z to the stock front.For a better workflow in Turning operations, the Safe Z override parameters were moved after the Approach Retract parameters in the Linking tab.In the Turning Profile operation, added the ability for the tool to machine some distance below inner radius in order to get rid of unmachined nubs.Added the ability for a grooving tool to go a specified distance below the inner radius while facing the part in a groove turning operation. This reduces the maximum stepdown amount so that each step can be equal.
0 Comments
Leave a Reply. |